Download Now
ZDesigner TLP 3842 Driver

The Zebra logo and the zebra head design are both registered trademarks and TLP is a service mark of ZIH Corp. Windows and MS-DOS are g: ZDesigner. The Zebra TLP 's dpi printhead enables high quality, crisp, clear printing in applications requiring data such as two-dimensional barcodes, fine text or composite graphics. Thermal transfer, dpi, 2 ips, 4" print width, serial, USB & ZebraNet PrintServer II interfaces. Download the latest drivers for your ZDesigner TLP to keep your Computer up-to-date.


Type: Driver
513 (3.86)
Downloads: 1077
File Size: 22.1Mb
Supported systems: Windows 10, 8.1, 8, 7, 2008, Vista, 2003, XP
Price: Free* [*Free Registration Required]

Download Now
ZDesigner TLP 3842 Driver

Here's a link to this great service Good luck!

Tlp driver windows 7 64bit

Posted on Jan 02, This printer requires special software to print labels with. It uses a unique PCL language to work with. Thats why when you use these printers ZDesigner TLP 3842 Fedex or UPS software, it typically downloads forms first before working. Zebra used to see a label designer program to work with it.

You might want to check with them to see if they still carry it. Posted on Jul 29, Zebra TLP Labels printing upside down How do we correct?

TLP 3842 Desktop Printer Support

Change orientation in the printer driver. Posted on Nov 20, Hi can you help? My zebra TLP printer keeps. If you are using a ribbon remove it and perform a calibration, hold down feed key for 2 seconds as you power on, release key and wait for it to complete its calibration, when it has stopped shifting labels wait for 10 secs to be sure ZDesigner TLP 3842 THE FEED KEY to exit dump mode.


If it has successfully calibrated it will feed a label each time you hit feed key. Re-install ribbon, make sure ribbon is pushed formly onto drive sprockets and then re-run the calibration. If this does not fix problem.


This will automatically reset printer to factory default condition. The printer driver should be set to Continuous or it will think it is still Gap or Black Mark.

Please adjust accordingly. Posted on Dec 20, Zebra e will skip leaving a blank label while printing. You need to calibrate.

Hold down the feed key while powering the printer on, then let go. The printer will calibrate, print a config label, then fo into dump mode.

Press the fee key again to go out of dump. Of your issue persists, there could be a problem with yoru media, or with the commands that you are sending to the printer.

JohnCas's advice did the trick To continue this discussion, please ask a new question. Get answers from your peers along with millions of IT pros who visit Spiceworks.

I have tried: Best Answer. JohnCas Apr 20, at We found 8 helpful replies in similar discussions:. Fast Answers! Ghost Chili.

Related Posts